Siemens ARTIS 2 S Service Manual download pdf (Page 130)

100

101

System Operation

Unit Movements

24 / 94 AXA4-100.620.08.01.02 Operator Manual

Table movements

Raising / lowering the table

u Press the key for the required movement and keep it pressed until the re-

quired table height is reached.

– The table height is changed immediately.

The speed of the upward table movement depends on the pressure exerted on

the key:

o light pressure: low speed

o strong pressure: high speed

Stopping in the isocenter

ISO stop You can program the table to stop automatically when the isocenter is reached.

u Set the table height for the isocenter.

u Press the Isocenter key.

– The LED lights up.

– The current table height is saved as isocenter height.

– The table stops every time this position is reached.

– The displays of the table coordinates X-Position, Y-Position, and IO-

Height are set to zero and show the relative coordinates (relative to the

patient with reference to the patient position) as long as the LED is lit.

No stop u Press the Isocenter key again.

– The LED goes out.

– The table moves continuously through the isocenter.

– The displays of the table coordinates X-Position, Y-Position, and IO-

Height indicate absolute (table) coordinates again.

The ISO stop function is automatically deactivated when a new patient is regis-

tered.

In the case of Artis dMP systems, downward table movements can result in a

collision with the C-arm. In that case, the movement stops.

If you press the key again, the table will no longer move downward, but (depend-

ing on configuration) the stand will move downward!

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 605 606

Comments to this Manuals

No comments

Siemens ARTIS 2 S Service Manual Page 130

Comments to this Manuals

Related products and manuals for Unknown Siemens ARTIS 2 S