Siemens ARTIS 2 S Service Manual download pdf (Page 116)

100

101

System Operation

Unit Movements

10 / 94 AXA4-100.620.08.01.02 Operator Manual

Basic positions of the units

General basic positions

C-arm A C-arm can be in the following basic positions:

o C-arm rotation 0°

o C-arm angulation 0° (FD overtable position)

And with Artis dMP:

o C-arm rotation 180° (FD undertable position)

In this position the C-arm is rotated through 180° so that the FD is under the

patient.

Patient table The patient table can be in the following basic positions:

o Table tilt horizontal (0°)

o Table height isocenter

o Tabletop center position (Artis dMP only)

Isocenter The isocenter is the center of rotation, the fixed point of a C-arm. If an organ is in

this center of rotation, the image of the organ remains in the same place on the

monitor during C-arm angulations.

➩ “Stopping in the isocenter” on page 24.

Stopping in the basic positions

By pressing a button, you can release stops for C-arm movements beyond a basic

position.

u Press the zero stop button.

– The LED lights up.

– Movements stop at the basic positions.

u If you now release the button and operate the operating element again, move-

ment is resumed.

No stop u Press the zero stop button again.

– The LED goes out.

– Movements are executed continuously beyond the basic positions.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 605 606

Comments to this Manuals

No comments

Siemens ARTIS 2 S Service Manual Page 116

Comments to this Manuals

Related products and manuals for Unknown Siemens ARTIS 2 S