TC63 AT Command Set
15.1 AT^SRSA
s
TC63_ATC_V00.490 Page 379 of 501 5/24/05
Confidential / Draft - Do not copy
SAP connection state
0 No SAP connection established.
1 SAP connection ongoing, i.e. peers exchange messages.
Notes
• If AT^SRSA with <dataForm> set to 1 (SAP) is given on the same serial multiplex channel as specified with
parameter <muxChan> the SAP data transfer mode is entered immediately. Therefore no command response
is issued by the TC63 in this case.
• If the TC63 is acting as SAP client and has switched to a remote SIM it starts accessing this SIM. If during
this time AT commands are used which need access to the SIM itself (e.g. AT+CPIN?) the TC63 responds
with "+CME ERROR: SIM blocked" or "+CME ERROR: SIM busy". Retry until SIM is fully accessible in this
case.
• If the TC63 is acting as SAP server and has released its SIM to a client it considers it as not accessible. There-
fore AT commands which require SIM access will be rejected with "+CME ERROR: SIM not inserted".
• Parameters <muxChan>, <dataForm> and <beaconPer> are applicable for RSA activation only.
<connState>
(num)
Comments to this Manuals