Siemens TC63 User Manual download pdf (Page 269)

100

101

TC63 AT Command Set

11.1 AT+CGACT

TC63_ATC_V00.490 Page 269 of 501 5/24/05

Confidential / Draft - Do not copy

PDP Context Identifier is a numeric parameter which specifies a particular PDP context definition. The param-

eter is local to the TE-MT interface and is used in other PDP context related commands.

1...2

Notes

• ATH will deactivate any PDP context.

• If the MT is in dedicated mode, the write command returns "+CME ERROR: operation temporary not allowed".

• A maximum of 2 contexts can be activated at the same time, no matter on which interface. Trying to activate

more than 2 contexts will cause "+CME ERROR: operation temporary not allowed". Note that, depending on

the provider, the number of activated contexts may be further restricted.

Remember that contexts may be activated implicitly by using the ATD*98# or ATD*99# GPRS compatibility

commands without specifying a <cid>.

• If an activated context will be deactivated without using the command AT+CGACT, then the result code "NO

CARRIER" will be issued to indicate the context deactivation. This happens for example if the context deac-

tivation is forced by the network or if deactivation results from a network deregistration with AT+COPS=2.

<cid>

(num)

1 2 ... 264 265 266 267 268 269 270 271 272 273 274 ... 500 501

Comments to this Manuals

No comments

Siemens TC63 User Manual Page 269

Comments to this Manuals

Related products and manuals for Hardware Siemens TC63