Siemens TC63 User Manual download pdf (Page 193)

100

101

TC63 AT Command Set

8.8 AT^MONI

TC63_ATC_V00.490 Page 193 of 501 5/24/05

Confidential / Draft - Do not copy

8.8 AT^MONI Monitor idle mode and dedicated mode

The AT^MONI command supplies information of the serving/dedicated cell. There are two ways to retrieve the

information: once on request by using the execute command or automatically every <period> seconds by using

the write command. To stop the periodic presentation type "AT" or "at".

Syntax

Parameter Description

Display period in seconds

1...254

Notes

• The two header lines (see Section 8.8.1, AT^MONI responses) are output after every ten data lines.

• The length of following output lines exceeds 80 characters. Therefore a terminal program may draw a carriage

return on a screen. However, this is not part of the response.

• The parameters LAC and cell are presented as hexadecimal digits, the remaining parameters are composed

of decimal digits.

• If the radio cell changes during a connection, the parameters PWR, RXLev and C1 of the 'Serving Cell' part

cannot be updated under certain conditions and therefore, are displayed as "-" (for conditions see also

AT+CREG). This is because the MS does not update the cell selection and reselection parameters since, in

this mode, they are not relevant for operation. When the connection ends, and the mobile is back to IDLE

mode, correct values will be given.

If the radio cell changes during a connection, it normally takes 1 or 2 seconds to update the parameters cell,

NCC and BCC. Until the information is received from the new base station, the default values will be shown

instead: cell="0000", NCC="-", BCC="-".

• If the BS supports frequency hopping during a connection, the dedicated channel (parameter chann) is not

stable. This mode is indicated by chann = 'h'.

Test Command

AT^MONI=?

Response(s)

^MONI:(list of supported <period>s)

Exec Command

AT^MONI

Response(s)

See: Section 8.8.1, AT^MONI responses

Write Command

AT^MONI=<period>

Response(s)

See: Section 8.8.1, AT^MONI responses

ERROR

+CME ERROR

Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last

SIEMENS ! % % % % % % ! ! !

(num)

1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 500 501

Comments to this Manuals

No comments

Siemens TC63 User Manual Page 193

Comments to this Manuals

Related products and manuals for Hardware Siemens TC63