Inverter with CU240B-2 and CU240E-2 Control Units
Operating Instructions, 01/2011, FW 4.4, A5E02299792B AB
3
Change history
Important changes with respect to the manual, edition 07/2010
New functions in firmware V4.4 In Chapter
Predefined settings for the interfaces of the converter
• Installing Control Unit (Page 42)
Two- and three-wire control via terminal block
• Inverter control (Page 149)
Unit changeover
• Application-specific functions
(Page 182)
Expanded options for controlling DC braking
• Braking functions of the inverter
(Page 187)
Expansion of the automatic restart with the addition of a new
mode
• Automatic restart and flying restart
(Page 204)
Trace via STARTER
• Commissioning with STARTER
(Page 71)
Revised descriptions In Chapter
The description of the Power Module PM240-2 and PM250-
2 has been removed. The release of this Power Module is
scheduled to be with firmware V4.5.
• Installing the Power Module
(Page 30)
• Technical data, Power Modules
(Page 266)
Wiring the terminal strip
• Installing Control Unit (Page 42)
• Adapt terminal strip (Page 89)
Settings of the USB interface for commissioning with
STARTER.
• Commissioning with STARTER
(Page 71)
Slave-to-slave communications via PROFIBUS DP
• Communication via PROFIBUS
(Page 102)
• Application Examples (Page 279)
Acyclic communication via PROFIBUS DP (data set 47)
• Acyclic communication (Page 117)
• Application Examples (Page 279)
Function overview
• Functions (Page 147)
Comments to this Manuals