Siemens Albatros2 AVS37 User Manual Page 83
- Page / 235
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
83/235
Siemens Schweiz AG Basic units RVS61.843 and RVS41.813 CE1U2355en_02
Landis & Staefa Division The settings in detail 3. Juli 2008
In Protection mode, the room temperature is prevented from falling below a certain
level. This means that the frost protection setpoint of the room temperature will be
maintained.
Line no. Operating line
HC1 HC2 HC3P
720 1020 1320 Heating curve slope
721 1021 1321 Heating curve displacement
726 1026 1326 Heating curve adaption
The heating curve generates the flow temperature setpoint, which is used to maintain a
certain flow temperature depending on the prevailing weather conditions. The heating
curve can be adjusted via a number of settings, thus matching heat output and room
temperature to individual needs.
The steeper the heating curve slope, the greater the change of flow temperature at low
outside temperatures. In other words, if the room temperature is not correct at low
outside temperatures, but at higher outside temperatures, the heating curve slope
needs readjusting.
Increasing the setting: Raises the flow temperature, especially when outside
temperatures are low.
Decreasing the setting: Lowers the flow temperature, especially when outside
temperatures are low.
The set heating curve is based on a room temperature setpoint of 20 °C. If the room
temperature setpoint is adjusted, the heating curve adapts automatically to the new
value.
20 10 0 -10 -20
-30
90
80
70
60
50
40
30
°C
°C
4
3,5
3
2,75 2,5 2,25
2
1,75
1,5
1,25
1
0,75
0,5
0,25
100
2000D02
Parallel displacement of the heating curve is used to change the flow temperature
evenly across the entire outside temperature range or, in other words, if the room
temperature is always too high or too low, a readjustment must be made via parallel
displacement.
Adaption of the heating curve is used by the controller to automatically adapt the
heating curve to the prevailing weather conditions. It can only be switched on or off. In
that case, a readjustment of heating curve slope and parallel displacement is not
required.
Frost protection
Heating curve
Heating curve slope
Heating curve
displacement
A
daption
- Siemens Switzerland Ltd 1
- HVAC Products 1
- Contents 3
- 1 Summary 9
- Wireless 10
- (optionally with additional 11
- 2 Safety notes 12
- 3 Mounting and installation 13
- Dimensions in mm 14
- 15/235 15
- 17/235 17
- B84/B9 2 18
- 19/235 19
- X50 of the basic unit 20
- AVS82.491/109 21
- 3.4 Operator unit AVS37.294 22
- 235 4M01 23
- 3.6 Room unit QAA55… 24
- 3.7 Room unit QAA75… 25
- Dimensions and drilling plan 26
- 3.8 RF components 27
- Operator section 29
- Testmode 29
- Removing the 31
- Batterie 31
- 3.8.4 RF repeater AVS14.390 33
- 4 Commissioning 35
- 5 Handling 36
- Xxxxxxxxxxxxxxxxxxxxxxxxxxx 37
- Raumtemperatur 39
- Text3 Text4 40
- 30:Flow sensor 1 40
- 41/235 41
- Room temperature 42
- 5.1.3 User levels 43
- Commissioning 44
- − − − / 8 30 °C 47
- − − − / -10 10 °C 47
- − − − / 1 100 % 47
- − − − / 0.5 4 °C 47
- − − − − − − / 0 20 °C 47
- − − − / 10 360 min 51
- − − − / -20 30 °C 52
- − − − / -30 50 °C 52
- − − − / -30 30 52
- − − − / 10 1000 52
- − − − / 10 600 min 54
- − − − − − − / 1 55
- − − − − − − / 0 100 % 68
- 5.2 QAA55 74
- 5.2.2 Programming 75
- 6 The settings in detail 77
- 40 Used as 78
- 79/235 79
- Heating circuits 1 and P 79
- All heating circuits 79
- 6.3 Radio links 80
- 6.4 Time programs 81
- 6.5 Holidays 81
- 6.6 Heating circuits 82
- Heating curve 83
- Heating curve slope 83
- HC1 HC2 HC3P 84
- 85/235 85
- Room temperature limitation 87
- Boost heating 87
- Quick setback 88
- Optimum start / stop control 88
- Raising the Reduced setpoint 89
- 830 1130 Mixing valve boost 90
- 832 1132 Actuator type 90
- 91/235 91
- 861 1161 1461 93
- 6.7 Cooling circuit 1 94
- 901 Operating mode 95
- 902 Comfort setpoint 95
- 907 Release 96
- 908 Flow setp at OT 25°C 96
- 909 Flow setp at OT 35°C 96
- 912 Cooling limit at OT 97
- 918 Summer comp start at OT 97
- 919 Summer comp end at OT 97
- 928 Room influence 98
- TRKw-SDR 99
- Mixing valve control 100
- Dewpoint supervision 100
- (dT TVKw) 101
- 6.8 Domestic hot water 102
- 1620 Release 103
- 1630 Charging priority 104
- Legionella function 105
- • Periodically 105
- • Fixed weekday 105
- 6.9 Hx pumps 106
- 107/235 107
- 6.10 Swimming pool 108
- 6.12 Heat pump 109
- 2801 Control cond pump 110
- 2802 Prerun time cond pump 110
- 2803 Overrun time cond pump 110
- Temperature request 111
- Source pump 111
- Line no. Operating line 112
- Compressor settings 114
- Compressor 2 116
- 2862 2862 117
- 2880 Use electric flow 118
- 119/235 119
- 2882 2882 120
- General parameters 121
- 2355_169aZ01 122
- Released 123
- 124/235 124
- 125/235 125
- Frost protection for 126
- 127/235 127
- 128/235 128
- 6.13 Cascade 130
- Heat source sequence 131
- Auto source seq exclusion 132
- Operating mode 133
- Overtemperature protection 133
- Control 133
- 6.15 Solar 135
- Priority 136
- DHW storage tank 136
- Buffer sensor 136
- Start function 137
- Collector frost protection 137
- Speed control 138
- Yield measurement 138
- 6.16 Buffer sensor 139
- 4720 Auto generation lock 140
- 4722 Temp diff buffer/HC 140
- Schichtschutz 141
- Always: 141
- 6.17 DHW storage tank 143
- 5055 Recooling temp 144
- 5056 Recooling heat gen/HCs 144
- 5057 Recooling collector 144
- 0 6121824 145
- DHW release 146
- External thermostat 146
- DHW sensor 146
- Excess heat draw 146
- Plant hydraulics 146
- 5101 Pump speed min 147
- 5102 Pump speed max 147
- Transfer strategy 148
- RVS61.843) 149
- 6.19 Configuration 150
- 5710 Heating circuit 1 151
- 5711 Cooling circuit 1 151
- 5712 Use of mixing valve 1 151
- Off ¦ On 152
- 5800 Heat source 153
- 5807 Refrigeration 153
- Output relay QX 155
- Line no 156
- Operating line 156
- 157/235 157
- 158/235 158
- 159/235 159
- Only RVS61 161
- Only RVS41 161
- 162/235 162
- Pressure measurement 10V 163
- Rel room humidity 10V 163
- Room temp 10V 163
- Release swimming pool 163
- 164/235 164
- 1/U1 and F2/U2) 165
- 167/235 167
- 170/235 170
- BX extension module 171
- H2 extension module 172
- 10V output UX 172
- Pt 1000 173
- 24h / day 174
- Time program HC 174
- Time program 5 174
- 176/235 176
- 177/235 177
- 6.20 LPB 178
- 6.21 Errors 181
- 229: Niederdruck 182
- Maintenance functions 185
- 186/235 186
- 187/235 187
- Manually 188
- Automatically 188
- 6.23 Input / output test 189
- Input test sensors 190
- Input test E 191
- enabling 191
- Input test H1, H2, H3 191
- 6.24 State 192
- State cooling circuit 193
- State heat pump 193
- State solar 194
- State buffer 194
- 6.25 Diagnostics cascade 196
- Time / start counter 198
- Heat pump air 198
- 6.27 Diagnostics consumers 200
- Heating circuits 1, 2, P 201
- Cooling circuit 1 201
- Domestic hot water 202
- Swimming pool 202
- Primary controller 202
- Common flow 202
- Input H1 203
- Water pressure 203
- 6.28 Pump kick 204
- 7 Plant diagrams 205
- Plant diagram 2: 206
- Plant diagram 3: 206
- Plant diagram 4: 207
- Plant diagram 5: 207
- Plant diagram 6: 208
- Plant diagram 7: 208
- Plant diagram 8: 209
- Plant diagram 9: 210
- Plant diagram 10: 210
- Plant diagram 11: 211
- Plant diagram 12: 211
- Plant diagram 13: 212
- Plant diagram 14: 212
- Plant diagram 15: 213
- Plant diagram 16: 214
- Plant diagram 17: 214
- Plant diagram 18: 215
- Plant diagram 19: 216
- Plant diagram 20: 216
- Plant diagram 21: 217
- Plant diagram 22: 218
- Plant diagram 23: 218
- Plant diagram 24: 219
- 220/235 220
- 8 Technical data 221
- Class 1K3, temp. -20…65 °C 222
- 0.5 0.75 1.0 1.5 mm 223
- 40 60 80 120 m 223
- Without packaging 224
- 8.7 Sensor characteristics 227
- 228/235 228
- 229/235 229
- 230/235 230
- 231/235 231
- 232/235 232
- 233/235 233
- 234/235 234
- 235/235 235
Related products and manuals for Thermostats Siemens Albatros2 AVS37
Thermostats Siemens TH 192 HC User Manual
(20 pages)
(20 pages)
Thermostats Siemens RDG Service Manual
(86 pages)
(86 pages)
Thermostats Siemens RDF301.50 Datasheet
(191 pages)
(191 pages)
Thermostats Siemens RDG160KN Service Manual
(21 pages)
(21 pages)
Thermostats Siemens TH 192 S Specifications
(12 pages)
(12 pages)
Thermostats Siemens RDF301.50H User Manual
(32 pages)
(32 pages)
Thermostats Siemens Albatros2 RVS46 User Manual
(156 pages)
(156 pages)
Thermostats Siemens RDF400 User Manual
(12 pages)
(12 pages)
Thermostats Siemens RDG160KN Service Manual
(60 pages)
(60 pages)
Thermostats Siemens TH 192 HC User Manual
(30 pages)
(30 pages)
Thermostats Siemens RDF600KN User Manual
(9 pages)
(9 pages)
Thermostats Siemens RDF301.50H User Manual
(15 pages)
(15 pages)
Thermostats Siemens RDF301 Service Manual
(17 pages)
(17 pages)
Thermostats Siemens RDF301 Service Manual
(19 pages)
(19 pages)
Thermostats Siemens RDG160KN Service Manual
(102 pages)
(102 pages)
Thermostats Siemens RDF300 User Manual
(31 pages)
(31 pages)
Thermostats Siemens RDF302 User Manual
(14 pages)
(14 pages)
© 2020, manymanuals.com. All rights reserved. | 2.403 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals