4-6 Optiset E Administrator Guide
Note:
If you forget your code, simply remove the battery from the
handset for a few seconds to disable the Lock mode.
Locating the Handset
The handset can be located by pressing the right-hand side key on the
base unit to send a ring signal to the handset. Pressing this key causes
the ringer on the handset to start a repeating 3-second sequence of one
second ring, one second soft beep, and one second off. If the ringer
slide switch is in the “OFF” position, only a soft beep will be heard.
Note:
The Locate function does not work when you have an
incoming call.
To locate the
handset
➩
Press the key on the right-hand side of the
base unit.
To cancel the Lo-
cate function
➩
Press the key on the right-hand side of the
base unit again.
Note:
The Locate function is automatically
canceled upon receiving an incoming call
or pressing the TALK key.
PhoneMail Message
When you receive PhoneMail messages, a message icon appears on the
display to indicate the presence of a message. Refer to “Reminder and
PhoneMail Messages on Display Phones” on page 6-2 for information
on how to display PhoneMail messages.
Note:
The message icon will not be displayed if you are active on the
phone. When the phone becomes idle, the message icon will
be displayed.
Comments to this Manuals