Siemens Advance Conference Telephone Troubleshooting Guide Page 29

  • Download
  • Add to my manuals
  • Print
  • Page
    / 242
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 28
Introduction 1-13
1. Introduction
Direct Wall Mounting
If you do not have a standard wall plate, you can mount your base unit
directly on a wall. Before mounting your base unit, consider the
following:
Select a location away from electrical cables, pipes, or other items
behind the mounting location that could cause a hazard when
inserting screws into the wall.
Make sure the wall material is capable of supporting the weight of
the base unit.
Use #10 screws with anchoring devices suitable for the wall
material where the base unit will be placed.
Insert mounting
screws into wall
Insert two mounting screws 3
15/16 inches
apart. Allow about 3/16 of an inch between
the wall and the screw heads for mounting
the phone.
Attach the AC
adapter cord to
the base unit
Plug one end of the AC adapter into the
base unit. Place the AC adapter cord inside
the molded channel of the wall mount
stand.
Connect the
telephone line
Plug one end of the telephone cord into the
line jack on the base unit. Then place the
telephone cord inside the molded channel
on the bottom of the wall mount stand.
Make sure that the phone jack supports the
U
P0/E
digital interface of the
communications server.
Install the base
unit on the posts
of the wall screws
Place the base unit on the posts of the wall
screws and push down until it is firmly
seated.
Apply power to
the base unit
Plug the AC adapter into a standard 120V
AC electrical outlet.
Page view 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 241 242

Comments to this Manuals

No comments