Siemens ADVANCE NETWORK COMMUNICATIONS BOARD/DATANET 20005 User Manual download pdf (Page 50)

Command Descriptions, Continued

download

Use this command to load new software into the device via the RS-232

Configuration port. The procedure for software download is:

1. Make sure you have a “rom.mot” file available for download.

2. Log into the target Hub through the RS-232 port, using HyperTerm.

3. Type “download” at the hub’s prompt (“>”). The hub will print with

some messages and will then prompt to begin transmitting the

download file.

4. Transmit the download file. Use the HyperTerm “Transfer --> Send

Text File…” command. Find the “rom.hex” file using the browser

window. You may have to select “Show all files” in the “Files of type”

window to see the “rom.mot” file.

5. After you have selected the “rom.mot” file and click on “OK,”

HyperTerm will begin transmitting records to the Hub. The Hub will

respond by periodically displaying addresses as the file downloads.

6. After about 4 minutes 30 seconds, the download will be complete.

The hub will then display messages indicating that the download has

completed, and it is erasing and programming the FLASH memory.

7. Finally, the Hub will reset, and display a new login prompt.

list

Enter the list command at any time from the Configuration Management

interface to see event buffer messages. The list command has an

internal current sequence number that is set to 1 each time a

Configuration Management login occurs. The list command will show 10

messages each time it is entered, beginning with the current sequence

number. The current sequence number is updated each time list is used.

A new current sequence number can be entered with the list command:

40 • Command Summary 2000592-001

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 71 72

No comments

Siemens ADVANCE NETWORK COMMUNICATIONS BOARD/DATANET 20005 User Manual Page 50