Siemens ADVANCE NETWORK COMMUNICATIONS BOARD/DATANET 20005 User Manual download pdf (Page 41)

Setting Network Address, Continued

See Assigning an IP Address, page 32 to learn how to assign an IP

Address.

Learning Hint

4. To configure the ANCB address, at the Local > prompt type:

config address ip xxx.xxx.xxx.xxx

Where xxx.xxx.xxx.xxx should be replaced with a 12-digit unique

network address. See Assigning an IP (Internet Protocol) Address

page

32.

5. Press ↵ Enter.

6. The following message appears: Configuration change verified

7. To configure the ANCB subnetwork, at the Local > prompt type:

config netmask xxx.xxx.xxx.xxx

8. Where xxx.xxx.xxx.xxx is the subnet mask for your network.

Typically, this would be in the range 255.255.0.0 through

255.255.255.0.

9. Press ↵ Enter.

10. To configure the ip router address at the Local > prompt type: config

iproute x

An IP router address is not always required. This command sets the

address of the IP router. Your network administrator can help you

choose an address.

This field can be left to the default setting of 000.000.000.000 if an IP

router is not used

11. Press ↵ Enter.

This completes the necessary ANCB Configuration. To display the

current settings, type at Local > prompt: config display

2000592-001 Data Communications Setup • 31

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 71 72

No comments

Siemens ADVANCE NETWORK COMMUNICATIONS BOARD/DATANET 20005 User Manual Page 41