Siemens ADVANCE NETWORK COMMUNICATIONS BOARD/DATANET 20005 User Manual download pdf (Page 38)

Establishing a Connection, Continued

Password Format

A password name can consist of any combination of alphanumeric

characters. The alphanumeric name must have a minimum of five and a

maximum of twenty characters. The ANCB is shipped from the factory

with the word “password” entered as the default password name.

The user can change the password name at any time. To do this login

using the current password then type: “password stand stand”. Where

the word stand is your new password entered twice to verify that it was

properly entered.

How to Change

Password

How to Log Out

You may log out or close the Configuration and Diagnostic program at

any time by typing logout. However, the Configuration and Diagnostic

program will automatically log you out after five minutes.

How to Log On

The following procedure assumes that a PC is connected to the ANCB

Configuration port (Figure 4-1), and the PC HyperTerminal program has

been configured to communicate with the ANCB; see Configuring Your

PC, page

1. Open Windows HyperTerminal program.

2. Press ↵ Enter twice.

The following dialog box appears:

28 • Data Communications Setup 2000592-001

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 71 72

No comments

Siemens ADVANCE NETWORK COMMUNICATIONS BOARD/DATANET 20005 User Manual Page 38