Siemens ADVANCE NETWORK COMMUNICATIONS BOARD/DATANET 20005 User Manual download pdf (Page 47)

Command Descriptions, Continued

config address ip

This command sets the device IP address. Each device in the system

must have a unique IP address. Your TCP/IP network administrator can

help you choose appropriate addresses for your network. IP addresses

are entered in “dotted-decimal” notation. For example:

config address ip 192.10.6.123

The IP address is not automatically stored in non-volatile memory until

the reset command is entered. You can display the current IP address

with the config display command.

config display

This command displays the configuration parameters for the device.

config netmask

This command sets the IP subnet mask for the device. Your TCP/IP

network administrator can help you choose appropriate subnet mask for

your network. Subnet masks are entered in “dotted-decimal” notation.

For example:

config netmask 255.255.192.0

The subnet mask is not automatically stored in non-volatile memory until

the reset command is entered. You can display the current subnet mask

with the config display command.

config iproute

This command sets the address of the IP router to which the device

should send TCP/IP messages whose destinations do not reside on the

devices’ own network. Your TCP/IP network administrator can help you

choose appropriate router addresses for your DataNET hubs (a router

address is not required). Addresses are entered in “dotted-decimal”

notation. For example:

config iproute 192.10.6.1

2000592-001 Command Summary • 37

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 71 72

No comments

Siemens ADVANCE NETWORK COMMUNICATIONS BOARD/DATANET 20005 User Manual Page 47