102 U41272-J-Z385-3-76
Backing up/restoring the SMC Functions of the System Management Console
4.5.2.2 Restoring the system drive of the SMC
To restore the system drive, you will need:
– The DDS4 data cartridges (150 m) with the backed up data of the system drive
– The CD-ROM (1 of 2) with the Solaris software for the SMC
WARNING!
The restore procedure explained below should only be carried out by a qualified
service engineer.
Proceed as follows to restore the system drive:
1. Log on at the SMC as root.
2. Switch to OBP mode by entering the following command:
SMC# /usr/sbin/shutdown -g0 -y -i0
3. Insert the Solaris CD-ROM in the CD-ROM drive.
4. Insert the data cartridge containing the backed up system drive in the DAT drive. Check
beforehand that the data cartridge is write-protected, i.e. that the write protection slider
is set at “writeable”.
5. Start Solaris 8 in single user mode from the CD-ROM:
ok boot cdrom -s
6. When a prompt appears, enter the command format. The system disks available for
selection are offered.
Example
Enter the number of the required system disk (in the example 0 for c0t0d0).
Close the menu with q (quit).
!
#format
Searching for disks...done
AVAILABLE DISK SELECTIONS:
0. c0t0d0 <sfdsk type1.0; ST320420A cyl 39533 alt 2 hd
16 sec 63>
/pci@1f,0/pci@1,1/ide@3/dad@0,0
Specify disk (enter its number):
Comments to this Manuals