Siemens SISTORE AX9 User Manual download pdf (Page 19)

Installation

2.13 Connecting to the USB Port

Fig. 14 USB connector.

Two USB ports are provided to connect external hard disk drives, CD-RW or flash

drive for clip copy or system upgrade. Position the external drive close enough to

the DVR so that you can make the cable connections, usually less than 6 feet.

Use the USB cable provided with the drive to connect it to the DVR.

2.14 Factory Reset

Fig. 15 Factory reset switch.

The DVR has a Factory Reset switch to the right of the USB port. This switch will

only be used on the rare occasions that you want to return all the settings to the

original factory settings.

CAUTION When using the Factory Reset, you will lose any setting you have made.

To reset the unit, you will need a straightened paperclip:

1. Unplug the power to turn the DVR off.

2. Plug the power to turn it on again.

3. While the DVR is initializing, poke the straightened paperclip in the unlabeled

hole above the PAL / NTSC switch.

4. Hold the switch until all the LEDs on the front panel are lit.

NOTE:

When the DVR successfully resets to factory defaults all the LEDs on the front panel flash three times.

5. Release the reset switch. All of the DVR’s settings are now at the original

settings it had when it left the factory.

Siemens Building Technologies SISTORE AX9 AX16_EN.doc

Fire & Security Products 09.2004

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 91 92

No comments

Siemens SISTORE AX9 User Manual Page 19