Siemens TC65 Specifications Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 120
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
TC65 Hardware Interface Description
Confidential / Released
s
TC65_HD_V02.000 Page 7 of 120 08.06.2006
0 Document History
Preceding document: "TC65 Hardware Interface Description" Version 01.041
New document: "TC65 Hardware Interface Description" Version
02.000
Chapter What is new
1.3 Added CE logo. Updated list of standards.
2.1 Updated operating temperatures. Added further firmware download options. Updated
audio features.
3.3.1.1 Added further details on timing after power-up.
Added alert message “SHUTDOWN after Illegal PowerUp”
3.3.1.1 More details on IGT timing depending on Power-Down or Charge-only mode.
3.3.1.2 New chapter: Configuring the IGT Line for Use as ON/OFF Switch
3.3.2 New chapter: Signal States after Startup.
3.3.4.1 Revised Table 7: Temperature dependent behavior.
3.4 Minor text change.
3.5, 9 Removed all information related to specific types of batteries and specific vendors.
3.5.3 Updated battery specifications in Table 8.
3.5.5 More detailed description of charging timers.
3.5.6, 3.7 Described transition from Charge-only to Normal mode by switching off Airplane mode.
3.3.1.3,
3.5.6, 3.7
To change from Charge-only mode to Normal mode the IGT line must be pulled low for
at least 2s and then released. High state of IGT lets TC65 enter Normal mode.
3.6 New chapter: Power Saving
3.12 TC65 does not support generic USB 2.0 High Speed hubs.
3.15.2.2 Added remarks on VMIC behaviour.
3.15.2.3 Replaced remark on VMIC behaviour.
3.15.4 Bit clock frequency increased from 128 to 256 kHz. Added ±100ns jitter. Modified
Figure 29.
3.16 Completely revised chapter: Analog-to-Digital Converter (ADC)
3.17 New chapter: GPIO Interface
5.1 New maximum values for voltage at analog pins with VMIC on/off.
5.2 Specified board / battery temperatures and ambient temperatures.
5.3 Changed storage air temperature.
5.5
Specified internal pull-down resistors 330kΩ at TXD0, RXD0, TXD1, RXD1. Changed
all
V
IH
min values from 2.0 to 2.15V. Corrected USB_DP row. Added recommendation to
connect pull-up or pull-down resistors to GPIO pins if configured as output.
5.6 Table 27: Different current consumption depending on whether autobauding enabled /
disabled.
Table 28, Table 29: Updated current consumption during Tx burst for GSM
850, 900, 1800 and 1900.
5.7 New chapter: Electrical Characteristics of the Voiceband Part
7 Described greater flexibility for using ASC0, ASC1 and USB.
9.1 Added / updated Siemens ordering numbers for TC65
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 119 120

Comments to this Manuals

No comments