Siemens TC65 Specifications Page 45

  • Download
  • Add to my manuals
  • Print
  • Page
    / 120
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 44
TC65 Hardware Interface Description
Confidential / Released
s
TC65_HD_V02.000 Page 45 of 120 08.06.2006
Table 8: Specifications of battery packs suitable for use with TC65
Battery type Rechargeable Lithium Ion or Lithium Polymer battery
Nominal voltage 3.6V / 3.7V
Capacity Recommended: 1000mAh to 1200mAh
Minimum: 500mAh
NTC 10k ± 5% @ 25°C
approx. 5k @ 45°C
approx. 26.2k @ 0°C
B value range: B (25/85)=3423K to B =3435K ± 3%
Overcharge detection voltage 4.325 ± 0.025V
Overdischarge detection voltage 2.5V
Overdischarge release voltage 2.6V
Overcurrent detection 3 ± 0.5A
Overcurrent detection delay time 4 ~ 16ms
Short detection delay time 50µs
Internal resistance <130m
Note: A maximum internal resistance of 150m should not
be exceeded even after 500 cycles and under extreme
conditions.
3.5.4 Charger Requirements
For using the implemented charging algorithm and the reference charging circuit
recommended in
[5] and in Figure 47, the charger has to meet the following requirements:
Output voltage: 5.2Volts ±0.2V (stabilized voltage)
Output current: 500mA
Chargers with a higher output current are acceptable, but please consider
that only 500mA will be applied when a 0.3Ohms shunt resistor is
connected between VSENSE and ISENSE. See
[5] for further detail.
3.5.5 Implemented Charging Technique
If all requirements listed above are met (appropriate external charging circuit of application,
battery pack, charger, AT^SBC settings) then charging is enabled in various stages
depending on the battery condition:
Trickle charging:
Trickle charge current flows over the VCHARGE line.
Trickle charging is done when a charger is present (connected to VCHARGE) and the
battery is deeply discharged or has undervoltage. If deeply discharged (Deep Discharge
Lockout at V
BATT+
= <2.5V) the battery is charged with 5mA, in case of undervoltage
(Undervoltage Lockout at V
BATT+
= 2.5…3.2V) it is charged with 30mA.
Page view 44
1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 119 120

Comments to this Manuals

No comments