Siemens TC65 Specifications Page 43

  • Download
  • Add to my manuals
  • Print
  • Page
    / 120
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 42
TC65 Hardware Interface Description
Confidential / Released
s
TC65_HD_V02.000 Page 43 of 120 08.06.2006
3.5 Charging Control
TC65 integrates a charging management for rechargeable Lithium Ion and Lithium Polymer
batteries. You can skip this chapter if charging is not your concern, or if you are not using
the implemented charging algorithm.
The following chapters contain an overview of charging and battery specifications. Please
refer to
[5] for greater detail, especially regarding requirements for batteries and chargers,
appropriate charging circuits, recommended batteries and an analysis of operational issues
typical of battery powered GSM/GPRS applications.
3.5.1 Hardware Requirements
TC65 has no on-board charging circuit. To benefit from the implemented charging
management you are required to install a charging circuit within your application according to
the
Figure 47.
3.5.2 Software Requirements
Use the command AT^SBC, parameter <current>, to enter the current consumption of the
host application. This information enables the TC65 module to correctly determine the end of
charging and terminate charging automatically when the battery is fully charged. If the
<current> value is inaccurate and the application draws a current higher than the final
charge current, either charging will not be terminated or the battery fails to reach its
maximum voltage. Therefore, the termination condition is defined as: current consumption
dependent on operating mode of the ME plus current consumption of the external
application. If used the current flowing over the VEXT pin of the application interface must be
added, too.
The parameter <current> is volatile, meaning that the factory default (0mA) is restored each
time the module is powered down or reset. Therefore, for better control of charging, it is
recommended to enter the value every time the module is started.
See
[1] for details on AT^SBC.
Page view 42
1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 119 120

Comments to this Manuals

No comments