Example "Motion"
5.8 Start diagnostics view
STEP 7 Basic V10.5
Getting Started, 12/2009, A5E02651459-01
191
5.8 Start diagnostics view
Introduction
The following steps show you how to start the diagnostics view of the technological object
"Axis". You can use the diagnostics function to monitor the motion jobs and the most
important status and error messages of the motor axis.
Requirements
● The technological object "Axis" has been created and correctly configured.
● The motion control instruction "MC_Power" has been created in the organization block
"Main [OB1]".
● The motion control instruction "MC_MoveRelativ" has been created in the organization
block "Main [OB1]".
Procedure
To start the diagnostics function, follow these steps:
1. Load the program to the PLC and activate the online connection. For additional
information see the "Loading the program to the target system (Page 48)" section.
2. Open the diagno
stics window of the technological object "Axis".
Comments to this Manuals