Simple example
2.3 Inserting and configuring a PLC
STEP 7 Basic V10.5
30 Getting Started, 12/2009, A5E02651459-01
Procedure
To configure the PLC, follow these steps:
1. Select the PROFINET interface in the graphic view.
The properties of the PROFINET interface are displayed in the Inspector window.
2. Enter the IP address of your PLC under "Ethernet addresses" in the Inspector window.
3. Save the project by clicking on the "Save project" icon on the toolbar.
4. Close the device and network editor.
Result
You have configured the PLC by setting the properties of the PROFINET interface.
Comments to this Manuals