STEP 7 Basic V10.5
Getting Started, 12/2009, A5E02651459-01
21
Simple example
2
2.1 Introduction
Steps
In the first part of the Getting Started you program an electric pushbutton for switching a
machine on and off. You start the machine by pressing the button once. If you press the
button again the power supply is interrupted and the machine switched off.
To do so, follow these steps:
● Create project
● Configure PLC
● Create program
● Load program in the PLC
● Test program
● Create HMI screen
2.2 Create project
Introduction
The following steps show you how to create a new project. In the project, the data and
programs that arise from the creation of an automation task are stored in an orderly manner.
For this example, open the Totally Integrated Automation Portal in the portal view. The Start
portal contains commands for creating a new project and for opening an existing project.
Comments to this Manuals