RUGGEDCOM ROS
User Guide
Chapter 5
Setup and Configuration
Adding a Device Address 149
If device addresses have not been configured, add addresses as needed. For more information, refer to
Section 5.4.17.2, “Adding a Device Address”.
Section 5.4.17.2
Adding a Device Address
To add a device address, do the following:
1. Navigate to Serial Protocols » Configure Device Addresses. The Device Address Table table appears.
Figure 107: Device Address Table Table
1. InsertRecord
2. Click InsertRecord. The Device Address Table form appears.
Figure 108: Device Address Table Form
1. Protocol List 2. Address Box 3. Remote IP Address Box 4. Port Box 5. Name Box 6. Apply Button 7. Delete Button
8. Reload Button
3. Configure the following parameter(s) as required:
Comments to this Manuals