RUGGEDCOM ROS
User Guide
Chapter 5
Setup and Configuration
Configuring the Telnet Com Port Protocol 143
Parameter Description
For an incoming TCP connection (server), the local interface IP address on which to
listen for connection requests. An empty string implies the default: the IP address of the
management interface.
When both outgoing and incoming connections are enabled (client or server), this is the
remote IP address to which to place an outgoing TCP connection request or from which
to accept an incoming request.
Link Stats Synopsis: { Disabled, Enabled }
Default: Enabled
Enables link statistics collection for this protocol.
5. Click Apply.
Section 5.4.15
Configuring the Telnet Com Port Protocol
To configure the Telnet Com Port protocol for a serial port, do the following:
1. Make sure the serial port is configured to use the Telnet Com Port protocol. For more information, refer to
Section 5.4.5, “Configuring a Serial Port”.
2. Navigate to Serial Protocols » Configure Protocols » Configure Telnet Com Port. The Telnet Com Port
table appears.
Figure 99: Telnet Com Port Table
3. Select a serial port. The Telnet Com Port form appears.
Comments to this Manuals