Siemens MICROMASTER 440 User Manual download pdf (Page 109)

Issue 01/06 Parameter Description

MICROMASTER 440 Parameter List

6SE6400-5BB00-0BP0

109

r0968 Status word 1 Min: -

Datatype: U16 Unit: - Def: -

P-Group: COMM Max: -

Displays active status word of inverter (in binary) and can be used to diagnose which commands are active.

Bitfields:

Bit00 Drive ready 0 NO 1 YES

Bit01 Drive ready to run 0 NO 1 YES

Bit02 Drive running 0 NO 1 YES

Bit03 Drive fault active 0 NO 1 YES

Bit04 OFF2 active 0 YES 1 NO

Bit05 OFF3 active 0 YES 1 NO

Bit06 ON inhibit active 0 NO 1 YES

Bit07 Drive warning active 0 NO 1 YES

Bit08 Deviation setpoint / act. value 0 YES 1 NO

Bit09 PZD control 0 NO 1 YES

Bit10 Maximum frequency reached 0 NO 1 YES

Bit11 Warning: Motor current limit 0 YES 1 NO

Bit12 Motor holding brake active 0 NO 1 YES

Bit13 Motor overload 0 YES 1 NO

Bit14 Motor runs right 0 NO 1 YES

Bit15 Inverter overload 0 YES 1 NO

P0970 Factory reset Min: 0

CStat: C Datatype: U16 Unit: - Def: 0

P-Group: PAR_RESET Active: first confirm QuickComm.: No Max: 1

P0970 = 1 resets all parameters to their default values.

Possible Settings:

0 Disabled

1 Parameter reset

Dependency:

- First set P0010 = 30 (factory settings).

- Stop drive (i.e. disable all pulses) before you can reset parameters to default values.

Note:

The following parameters retain their values after a factory reset:

- P0014 Store mode

- r0039 CO: Energy consumption meter [kWh]

- P0100 Europe / North America

- P0918 CB address

- P2010 USS baud rate

- P2011 USS address

P0971 Transfer data from RAM to EEPROM Min: 0

CStat: CUT Datatype: U16 Unit: - Def: 0

P-Group: COMM Active: first confirm QuickComm.: No Max: 1

Transfers values from RAM to EEPROM when set to 1.

Possible Settings:

0 Disabled

1 Start transfer

Note:

All values in RAM are transferred to EEPROM.

Parameter is automatically reset to 0 (default) after successful transfer.

The storage from RAM to EEPROM is accomplished via P0971. The communications are reset, if the

transfer was successful. During the reset process communications will be interrupted. This creates the

following conditions:

- PLC (e.g. SIMATIC S7) enters Stop mode

- Starter automatically recovers communications once they are re-established.

- Drivemonitor is displayed "NC" (not connected) in the status line or "drive busy".

- BOP displays "busy"

After completion of the transfer process, the communication between the inverter and the PC-tools (e.g.

Starter) or BOP is automatically re-established.

Level

1 ... 108 109 110 ... 328

Comments to this Manuals

No comments

Siemens MICROMASTER 440 User Manual Page 109

Comments to this Manuals

Related products and manuals for Power adapters & inverters Siemens MICROMASTER 440