Siemens Sinumerik 810T User Manual download pdf (Page 15)

EMCO WINNC SINUMERIK 810/820 T

B 3

BASICS

Input of the

Zero Offset

Four zero offsets can be entered (e.g. for four diffe-

rent clamping devices).

• Press the softkey SETTING DATA in any mode.

• Press the softkey ZERO OFFSET.

• The screen shows the input pattern for the zero

offset G54. The particular offsets G54 - G57 can

be selected with softkeys.

• Below ZERO OFFSET the measured values (e.g.:

X=0, Z=length of chuck) are entered.

• Corrections to this value can be entered below ZO

ADDIT. These corrections will be added.

• Move the cursor to the value to be altered with the

keys .

• Enter the new value and press the key .

• The inverse input mark jumps to the next input

field.

Input pattern for Zero Offset G54

Input of the Coordinate Rotation

A coordinate rotation can be programmed for every

zero offset. This coordinate rotation becomes active

at the call-up of the zero offset.

• Press the softkey SETTING DATA in any mode.

• Extend softkey line (key

) and press softkey

ROTAT. ANGLE.

• The screen shows the input pattern for coordinate

rotation. The single rotations for G54 - G57 can be

entered in this pattern, the rotations for G58 and

G59 are determined in the CNC program.

• Move the cursor to the value to be altered with the

keys .

• Enter the new value and press the key .

• The inverse input mark jumps to the next input

field.

Input pattern for coordinate rotation

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 89 90

No comments

Siemens Sinumerik 810T User Manual Page 15