Siemens TE717209RW User Manual download pdf (Page 18)

14

en

Water filter

A new water lter must be rinsed before it

can be used.

● To do this, press the water lter rmly

into the water tank 11 with the aid of the

measuring spoon 14. Fill the water tank

with water up to the “max” mark.

● Turn the rotary knob 6 to select start

and press the start button 8.

Place 1 l container

Place suction pipe in container



start

● Place a container with a capacity of 1 litre

under the milk frother 10.

● Place the end of the suction pipe 10d in

the container.

● Press the start button 8. Water will now

ow through the lter to rinse it.

● Next, empty the container.

The appliance is ready for use again.

Info: Rinsing the lter simultaneously

activates the setting for the “change lter”

display.

You can nd detailed information about the

water lter in the enclosed lter instructions.

The lter is no longer effective when the

Service - change filter display appears, or

at the latest after two months. It needs to be

replaced for reasons of hygiene and so that

there is no build-up of limescale (this could

damage the appliance).

Replacement lters can be obtained from

retailers (TZ70003) or from customer

service (575491).

If no new lter is used, turn the

Water filter setting to no.

Info: If the appliance has not been used for

a prolonged period (for example, when you

are on vacation), the existing lter should

be rinsed before the appliance is used

again. To do this, simply dispense a cup of

hot water.

Transport. lock

● To avoid damage caused by frost during

transport and storage, the appliance must

be completely emptied rst.

Info: The appliance must be ready for use

and the water tank 11 lled.

● Press the start button 8. The appliance

automatically empties the pipe system

and switches off.

● Empty the water tank 11 and the drip

tray 23.

Factory reset

You can cancel your own settings and reset

the factory settings.

● To activate the factory settings, press the

start button 8.

Info: The appliance can also be reset to

the factory settings using a combination of

buttons. The appliance must be switched

off fully.

● Hold down the selection buttons < and >

4 and the on/off switch 1 O / I at the same

time for at least 5 seconds. Press the

start button 8. The factory settings are

now reactivated.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 171 172

Comments to this Manuals

No comments