Siemens GS..D.. User Manual download pdf (Page 17)

How to configure an Anybus PROFIBUS Slave module with a Siemens Step7 PLC

SCM-7032-026

Rev 2.1

www.anybus.com HMS Industrial Networks AB

Page 17 (30)

6 Anybus configuration

The Anybus product has to be configured for the same I/O sizes as set up in the PROFIBUS configuration.

Note: The I/O sizes are depending on the application, the configured I/O sizes in this chapter are just

examples.

Anybus-S Slave Interface and the Anybus PCI card:

The Anybus Slave Interface and the Anybus PCI card are configured by mailbox commands. Refer to

respective Fieldbus Appendix for details.

Anybus-IC:

The Anybus-IC is configured by the User Interface using for example the Windows Hyper Terminal. Refer to

the Design Guide for details.

Anybus CompactCom:

The Anybus CompactCom is configured by messages send by the application. Refer to the Design Appendix

for details.

Anybus Communicator and the Anybus X-gateway:

The configuration of the Anybus Communicator and the Anybus X-gateway is described in separate sections

below.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 29 30

No comments

Siemens GS..D.. User Manual Page 17