
How to configure an Anybus PROFIBUS Slave module with a Siemens Step7 PLC
SCM-7032-026
Rev 2.1
Figure 14 Adjusting the offset address.
The offset addresses can be chosen freely but certain restrictions may apply depending on what CPU is used.
When all the above settings are done it is possible to perform a download of the configuration to the PLC.
Press the Save and Compile button and then the download button.
Download button
Save and Compile button
Figure 15 Downloading the configuration to the PLC.
The bus will then go online and start data exchange when the PLC is set to run mode.
www.anybus.com HMS Industrial Networks AB
Page 13 (30)
Comments to this Manuals