Siemens SL370 User Manual download pdf (Page 62)

61

Appendix

Gigaset SL375 / AUS / A31008-M1903-C401-1-7619 / appendix.fm / 14.8.07

Version 4, 16.09.2005

Appendix

Care

¤ Wipe the base station, charging cradle

and the handset with a damp cloth (do

not use solvent) or an antistatic cloth.

Never use a dry cloth. This can cause a

build up of static.

Contact with liquid

If the handset has come into contact with

liquid:

1. Switch off the handset and remove

the battery pack immediately.

2. Allow the liquid to drain from the hand-

set.

3. Pat all parts dry, then place the handset

with the battery compartment open

and the keypad facing down in a dry,

warm place for at least 72 hours

(not in a microwave, oven etc.).

4. Do not switch on the handset again

until it is completely dry.

When it has fully dried out, you will nor-

mally be able to use it again.

Questions and answers

If you have any questions about using

your phone, visit us at

www.siemens.com/gigasetcustomercare

at any time. The table below contains a list

of common problems and possible solu-

tions.

Registration or connection problems with a

Bluetooth headset.

¥ Reset the Bluetooth headset (see the user

guide for your headset).

¥ Delete registration data from the handset

when de-registering the device (see

page 56).

¥ Repeat the registration process (see

page 56).

!

The display is blank.

1. The handset is not switched on.

¥ Press and hold the end call key a.

2. The battery pack is flat.

¥ Charge/replace the battery pack

(page 7).

The keys of a handset do not respond when

pressed.

The keypad lock is activated.

¥ Press and hold the hash key

#

(page 10).

"Base station x" flashes on the display.

1. The handset is outside the range of the base

station.

¥ Move the handset closer to the base sta-

tion.

2. The base station's range is reduced because

eco mode is activated.

¥ Deactivate eco mode (page 12) or

reduce the distance between the hand-

set and the base station.

3. The handset has been de-registered.

¥ Register the handset (page 43).

4. The base station is not switched on.

¥ Check the base station's mains adapter

(page 7).

Base Search flashes in the display.

The handset is set to Best Base and no base sta-

tion is switched on or within range.

¥ Move the handset closer to the base station.

¥ Check the base station's mains adapter

(page 7).

Handset does not ring.

The ringer tone is switched off.

¥ Activate the ringer tone (page 51).

You cannot hear a ringer/dialling tone from

the fixed network.

The phone cord supplied has not been used or

has been replaced by a new cord with the

wrong jack connections.

¥ Please always use the phone cord supplied

or ensure that the jack connections are cor-

rect when purchasing from a retailer

(page 7).

Error tone sounds after system PIN prompt.

You have entered the wrong system PIN.

¥ Reset the system PIN to 0000 (page 58).

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 75 76

Comments to this Manuals

No comments