Siemens TE803509DE User Manual download pdf (Page 42)

38

en

Water filter

A new water  lter must be rinsed before it

can be used.

● To do this, press the water  lter  rmly

into the water tank 11 with the aid of the

measuring spoon 14. Fill the water tank

with water up to the “max” mark.

● Turn the rotary knob 6 to select start

and press the start button 8.

Place 1 l container

Place suction pipe in container



start

● Place a container with a capacity of 1 litre

under the milk frother 10.

● Place the end of the suction pipe 10d in

the container.

● Press the start button 8. Water will now

 ow through the  lter to rinse it.

● Next, empty the container.

The appliance is ready for use again.

Info: Rinsing the  lter simultaneously

activates the setting for the “change  lter”

display.

You can  nd detailed information about the

water  lter in the enclosed  lter instructions.

The  lter is no longer effective when the

Service - change filter display appears,

or at the latest after two months. It needs to

be replaced for reasons of hygiene and so

that there is no build-up of limescale (this

could damage the appliance).

Replacement  lters can be obtained from

retailers (TZ70003) or from customer

service (575491).

If no new  lter is used, turn the Water

filter setting to no.

Info: If the appliance has not been used for

a prolonged period (for example, when you

are on vacation), the existing  lter should

be rinsed before the appliance is used

again. To do this, simply dispense a cup of

hot water.

Transport. lock

● To avoid damage caused by frost during

transport and storage, the appliance must

be completely emptied  rst.

Info: The appliance must be ready for use

and the water tank 11  lled.

● Press the start button 8. The appliance

automatically empties the pipe system

and switches off.

● Empty the water tank 11 and the drip

tray 23.

Factory reset

You can cancel your own settings and reset

the factory settings.

● To activate the factory settings, press the

start button 8.

Info: The appliance can also be reset to

the factory settings using a combination of

buttons. The appliance must be switched

off fully.

● Hold down the selection buttons < and

> 4 and the on/off switch 1 O / I at the

same time for at least 5 seconds. Press

the start button 8. The factory settings

are now reactivated.

TE803_806_1DE.indb 38 08.05.2013 12:07:52

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 111 112

Comments to this Manuals

No comments