Siemens Gigaset SL910A User's Guide Page 93

  • Download
  • Add to my manuals
  • Print
  • Page
    / 112
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 92
91
Updating the base firmware
Gigaset SL910/910A / MEA EN / A31008-M2300-A601-1-UZ19 / appendix.fm / 14.12.2011
Version 4.1, 21.11.2007
Starting a firmware update
Prerequisite: The base is connected to the Internet and is in idle status.
Starting the firmware update manually
¤ In the Settings menu (¢ page 24), touch [ Ê System].
¤ Scroll to Firmware Update. ¤ Touch the corresponding . ¤ Touch Update
Firmware.
¤ Enter the system PIN and confirm with è.
If a new version of the base firmware is available, message New firmware available
- Update? is displayed.
¤ Press Ye s to confirm.
Setting the automatic firmware update
¤ In the Settings menu (¢ page 24), touch [ Ê System].
¤ Scroll to Firmware Update. ¤ Activate/deactivate the function with the button
next to Automatic Check.
If the function is activated, the base will check daily whether a new firmware ver-
sion is available. If this is the case, you will receive the message Start download?.
¤ Press Ye s to confirm.
If you answer the prompt with No, the message will not be displayed again until the
next firmware version is available. You can perform the firmware update manually
(
¢ page 91).
Please note
u The firmware update can take up to six minutes, depending on the quality of
your DSL connection.
u During the update, the registered handsets temporarily lose their connec-
tion to the base.
Please note
If the phone is not connected to the Internet at the time the check for new
firmware is carried out (e.g., no router connection), then the check will be car-
ried out as soon as the phone is reconnected to the Internet.
Page view 92
1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 111 112

Comments to this Manuals

No comments