Siemens Gigaset SL75 WLAN Specifications download pdf (Page 17)

16

Connecting the handset with the network

Gigaset SL75 WLAN / en / A31008-M700-B112-1-7619 / starting.fm / 24.4.06

Version05.08.2005

First battery charge and discharge

The correct charge status can only be dis-

played if the battery is first fully charged

and discharged through use.

¤ To do this, leave the handset in the

charging cradle without interruption

until the battery icon stops flashing in

the display (approx. 6hours). Your

handset need not be switched on for it

to charge.

¤ Remove the handset from the cradle

and do not put it back until the battery

is completely discharged.

Please note:

u Always repeat the charge and dis-

charge process if you remove the bat-

tery from the handset and insert it

again.

u The battery may heat up during charg-

ing. This is not dangerous.

u After a time, the charge capacity of the

battery will decrease for technical rea-

sons.

Charging procedure

Please note the following when charging

the handset:

u Place the deactivated handset in the

charging cradle – the handset switches

to charging mode (the charge icon

appears in the display). The handset

remains deactivated. This also applies if

the handset has switched off automat-

ically (empty battery).

u You can activate the handset while it

is charging if you wish to remain con-

tactable (press the a end call key).

Exception: if the battery is completely

discharged before being placed in the

charger (the handset has not been used

for a long period, e.g. while you were

on holiday), it may be some time before

the handset can be activated while

being charged (it needs to build up a

minimum charging capacity first).

Leave the handset in the charging cra-

dle for a while and then try to activate

it again.

u Uninterrupted, successful charging

can only be guaranteed if you do not

switch off the handset in the charg-

ing cradle.

Your handset is now ready for operation!

¤ Connect the handset to the network

(page 16).

¤ If necessary, set the date and time

(page 67).

To ensure your Gigaset is always

completely up to date,

you can download updates of the handset

firmware from the Internet, save them on

your PC and load them onto the handset

using the Web configurator (page 103).

Connecting the handset

with the network

To be able to make calls with your hand-

set, you must connect it to the access

point/WLAN router and set up an SIP serv-

ice (or SIP server). To do this, you must

save the necessary access data in an

access profile.

Checking the access point

requirements

Before you log the handset into the

WLAN, you should check the following:

u If access restriction through entered

MAC addresses is activated for the

access point, you must record the

handset's MAC address in the access list

before logging the handset in.

Note:

After the first battery charge and discharge,

you may replace your handset in the charging

cradle after every call.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 149 150

Comments to this Manuals

No comments