Siemens NCZ Specifications download pdf (Page 100)

8.2 DMP compact module 16O (6FC5111-0CA02-0AA2)

8-100

SINUMERIK 810D Equipment Manual Configuration CCU (PHC) – 03/2006 Edition

Table 8-3 Technical data of DMP compact module 16O

Output load for signal “1” (rated value)

– Ohmic load 500 mA

– Lamp load 5 W

– Inductive load 500 mA

Short-circuit protection Yes

Power loss at 30 V Max. 3.8 W

Operating frequency for

– Ohmic load 100 Hz

– Lamps 11 Hz

– Inductive load (for rated

current, higher values are

permissible for lower cur-

rents)

2 Hz

Total load capability at 55



C (relative to the total rated

current of all outputs)

50 %

Delay time for tp

= max. 0.5 ms

Delay time for tp

= max. 0.5 ms

Length for cables Max. 50 m

Weight about 160 g

Important

As of version C, a new output driver is used for the DMP compact module 16A.

The following behavior is to be observed:

In the event of a fault triggered by overcurrent or short-circuit, the outputs

automatically reconnect after the fault has been rectified. (previously: latching

disable until the output is reactivated by the PLC user program).

If one output is short-circuited, the three other outputs of the same half-byte can

also be disabled. In normal operation with currents < 0.7 A, there is no mutual

influence.

8 outputs each are powered by a power supply. For each group of 8 outputs

(2 x outputs 0 ... 7), the total of the output currents must not be greater than 2 A.

(This corresponds to a coincidence factor of 50 % if each output is under full

load). All 16 outputs can be loaded simultaneously with 0.25 A for example.

Important

If inductive loads are used, switching voltage peaks must be limited by external

free-wheeling diodes or RC connections.

8 DMP Com

act Modules

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 119 120

Comments to this Manuals

No comments

Siemens NCZ Specifications Page 100

Comments to this Manuals

Related products and manuals for Power generators Siemens NCZ