SCiemens HiPath Wireless System onfiguration and Deployment Guide SpectraLink's Voice Interoperability for Enterprise Wireless (VIEW) Certifica
Filtering 1. In the VNS Configuration screen, click the Filtering tab. 2. Select Default from the Filter ID drop-down list. a. Select all 3 optio
Multicast configuration 1. In the VNS Configuration screen, click the Multicast tab. 2. Select the Enable Multicast Support check box. 3. From th
Security 1. In the VNS Configuration screen, click the Privacy tab. 2. For WPA2 AES-CCKM, click the WPA-PSK option, clear the WPA v.1 check box, th
Quality of service 1. In the VNS Configuration screen, click the Policy tab. 2. From the Quality of Service drop-down list, select Voice VNS w/o WM
Connecting access points to the controller 1. Click the Reports button. 2. Make sure the controller is configured to accept new APs (this is select
Wireless APs address assignment 1. After all the APs have been connected and discovered by the controller, click Wireless APs tab. 2. Click the St
For each AP, follow the steps in the following sections. AP properties 1. In the Wireless APs screen, click the AP Properties tab. Select an AP to c
802.11b/g settings 1. In the Wireless APs screen, select the 802.11 b/g tab. 2. Select an AP to configure. 3. Under Base Settings: a. Set the D
Enable the radio 1. Click the VNS Configuration button. 2. Click the Topology tab. 3. Enable each AP’s b/g radio for each SSID. 4. Set No. of Ret
Network Topology The following topology was tested during VIEW Certification. It is important to note that these do not necessarily represent all &qu
Known Limitations 1. Beacons are sent from the AP inconsistently; therefore you may see decreased battery life on the handsets. 2. A hex-key is not
Controller Setup The setup steps described below refer to the network topology diagram shown in this document. Make sure all the access points are di
PN: 72-9961-00-B.doc Page 5
Assigning routing protocols to a wireless controller 1. In the Wireless Controller screen, click Routing Protocols in the navigation pane. 2. Enter
AP registration 1. Click the Wireless APs button. 2. Click AP registration in the navigation pane. 3. Enter all information for your APs (see scre
AP maintenance 1. In the Wireless APs screen, click AP Maintenance in the navigation pane. 2. Select the proper image file in the AP Images box and
Setting up SSID, Security and QOS 1. Click the VNS Configuration button. 2. Click the Topology tab. 3. Assign a subnet for clients for a specific
Comments to this Manuals