Siemens C10 User Manual download pdf (Page 4)

Controller Setup

The setup steps described below refer to the network topology diagram shown in this

document. Make sure all the access points are disconnected from the system if

configuring the system for the first time.

Assigning an IP address to a wireless controller

1. Log onto the controller by opening a web browser and connect to

https://192.168.10.1:5825/. The default username is admin; the default password is

abc123.

2. Click the Wireless Controller button.

3. In the navigation pane, click IP Addresses.

4. Change the value of esa0 to 192.168.110.10 for the IP Address, and to

255.255.255.0 for the Subnet mask.

5. Select the Mgmt and SLP check boxes for this port only (thus turning it on). Leave

these unchecked (off) for the other ports.

6. For Function, select Host Port if static routing is used. Otherwise, select Dynamic

Port

if OSPF is being used for routing and routing advertisements.

7. Enter esa0 for Multicast Support. Refer to the screen shot shown below.

8. Click the Save button.



This is for topologies where the SpectraLink gateway(s) and SVP Servers are

located adjacent to the esa0 port, as was done in this VIEW Certification test.

In topologies where the setup is different, this multicast setting should be

configured to whichever port the SpectraLink servers are adjacent to. This

setting permits proper wired replication of multicast data from the wireless

subnet.

PN: 72-9961-00-B.doc Page 4

1 2 3 4 5 6 7 8 9 ... 17 18

No comments

Siemens C10 User Manual Page 4