Siemens OpenStage 10 T Service Manual download pdf (Page 43)

beispiele.fm

Examples and HowTos

optiPoint Compatible Mode (V2R0)

A31003-S2000-M101-4-76A9, 2010-02-23

HiPath 3000/5000, HiPath 4000 - OpenStage 10/15/20/40/60/80 T, Administration Manual 4-7

4.3 optiPoint Compatible Mode (V2R0)

Some older versions of HiPath 3000 will not identify OpenStage TDM phones correctly. To

overcome this restriction, OpenStage 10 T / 15 T / 30 T phones with firmware from V2R1 on-

wards can be switched to an optiPoint500 compatible mode. In optiPoint mode, the phone

changes its Phone-ID to that of a corresponding optiPoint model, e. g. an OpenStage 10 T will

adopt the Phone-ID of an optiPoint500 Entry. For a complete reference, see the following table:

4.3.1 Switching Procedure for OpenStage 15 / 30

1. Press the menu button N for at least 5 seconds.

2. The menu LED starts flashing and the phone mode selection menu is shown on the dis-

play. The currently active phone mode is marked.

3. When pressing the up

m or down l key, the second, currently inactive, mode is shown.

4. Press the i key to select the optiPoint mode.

5. Press the i key again to confirm the selection and activate optiPoint mode.

6. After 5 seconds the phone performs a restart and comes up in the new operating mode.

OpenStage 10 T

<-> optiPoint500 Entry

OpenStage 15

<-> optiPoint 500 Standard

OpenStage 30

<-> optiPoint500 Advance

Phone Operating Mode:

[*] OpenStage

Phone Operating Mode:

[ ] OptiPoint

OptiPoint Operating Mode

Save and Restart

OptiPoint Operating Mode

Saved successfully!

1 ... 42 43 44 ... 54

No comments

Siemens OpenStage 10 T Service Manual Page 43