Siemens LI48632 User Manual download pdf (Page 32)

3. Tighten the two ﬁxing screws with a

screwdriver (cordless).

4. If required, shorten the wall cover to the

required dimension (e.g. saw off).

Attach the wall cover with the enclosed

clips.

Screw the wall cover to the wall

cupboard.

5. Feed the mains connection cable out of

the cupboard.

6. Connect the pipes in the wall cupboard.

– If required, attach the air hose to the

cupboard ceiling –.

7. Re-insert grease ﬁlter

(see Operating instructions).

Note: The extractor hood housing can be

clad inside the wall cupboard (e.g. with

chipboard).

If so, observe the following:

❑

The intermediate base must not be

placed on the extractor hood housing.

❑

Never attach cladding to the housing.

❑

Provide access for customer service.

Fitting into wall cupboard

 Check door alignment and readjust if

necessary.

1. Remove grease ﬁlter

(see Operating instructions).

2. Lift the extractor hood into the cupboard

from below until both ﬁxing lugs have

locked ﬁrmly into position.

❑

Align the extractor hood in the

cupboard.

❑

Carefully tighten both fastening screws.

 Check that the extractor hood is

secure in the cupboard.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 115 116

No comments

Siemens LI48632 User Manual Page 32