Siemens SL84A Technical Information download pdf (Page 37)

English

36

Power

Scrub

Plus

Regular

Wash

Cancel Drain

Delicate

/Econo

(Special Features, continued)

Changing the Cycle Completion Signal

Volume

Models With No LED Display:

1. Open the dishwasher door far enough to

expose the control buttons.

2. Press and hold down the right-most of the

two buttons labelled “Cancel Drain”, as

shown in Figure 28, then press and hold the

On/Off button. When the light on the “Cancel

Drain” button you are pressing illuminates,

and the tone begins to sound, release both

buttons.

3. Press the “Cancel Drain” button you

previously pressed until the tone is at the

desired volume, or until it is silent.

4. Press the On/Off Button.

5. Close the dishwasher door. The Cycle

Completion Signal is now set, and you may

wash your dishes as usual.

Models With An LED Display:

1. Open the dishwasher door far enough to

expose the control buttons.

2. Press and hold down the Delay Start

Button, then press and hold the On/Off

button. When the tone begins to sound and

the display shows a 0, 1, or 2 , release the

buttons.

3. Press the Delay Start Button button until

the tone is at the desired volume, or until it is

silent. The display will show a 0, 1, or 2 for

the volume level.

4. Press the On/Off Button.

5. Close the dishwasher door. The Cycle

Completion Signal is now set, and you may

wash your dishes as usual.

Additional Drying Heat

With this special feature you can raise the

temperature of the rinse water, which will

result in better condensation drying.

Front Control

1. Press and hold the left-most of the two

buttons labelled “Cancel Drain”, as shown in

Figure 29, then press and hold the On/Off

button. When the LED display shows a “0” or

a “1”, release both buttons. The light above

the left-most “Cancel Drain” button will begin

to flash.

2. Press the left-most “Cancel Drain” button

until the LED display shows a “1”, indicating

that the Additional Drying Heat is enabled.

3. If you wish to disable the Additional Drying

Heat, press the left-most “Cancel Drain”

button again. The LED display will show a “0”,

indicating that the Additional Drying Heat is

disabled.

4. Press the On/Off button. The light above

the left-most “Cancel Drain” button will stop

flashing. You may now wash dishes as

usual.

Figure 28/Ilus. 28

Special Features | Caractéristiques Spéciales | Caractísticas Especiales

Figure 29/Ilus. 29

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 65 66

Comments to this Manuals

No comments