50
Modification
Sequencer
Sequential control
- Introduction
- Basics
- Working with Sequencers
- Modification
- Solution Description, Example
- Test
Network 6 determines in which step the program jumps to
step 5. In the example, it jumps in step 0.
This is controlled by:
Setting M0.0 and resetting
M0.1 to M0.5.
If the program is to jump automatically to step 1 following step 5,
Network 6 must look like this.
This modification causes the drill to run automatically until
stopped by I0.0 or I0.5.
LatchingRevision
Pulse-Oper-
ated Switch
Off-Delay
Timer
Sequencer Appendix
Comments to this Manuals