Siemens SPCK 421 User's Guide download pdf (Page 24)

User programming via the keypad

User Menus

Siemens AB

A6V10209178

Security Products

26.09.2011

NOTICE

Where USER DURESS feature is enabled, consecutive user codes (i.e. 2906,

2907) are not permitted, as entering this PIN from the keypad would activate a

user duress event.

NOTICE

Engineer PINs should be noted down. If a PIN is forgotten, a factory default of the

system is required to reset PINs.

6.2.10 SMS

The SPC system support SMS communication from the panel to selected users’

mobile phones as well as users being able to control the SPC system remotely via

SMS. These two features work hand in hand as it allows the user to take action

using the SMS control after a SMS notification without the need to be physically at

the premises.

SMS control

The SMS control can be set up so that a remote user can send a SMS message to

perform the following actions at the panel:

 Setting / unsetting

 Enable / disable engineer

 Enable / disable manufacturer access.

 Mapping gate on/off.

SMS events

The SMS notification can be set up to send a range of events that occur on the

system such as:

 Alarm activation

 Confirmed alarms

 Fault & tamper

 Setting & unsetting

 Inhibit & isolate

 All other types of events

The SMS notification can operate with a PSTN modem if the PSTN operator

supports SMS over PSTN where as SMS control will need a GSM modem at the

panel. A GSM modem will support both SMS notification and control.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 34 35

No comments

Siemens SPCK 421 User's Guide Page 24