Siemens RUGGEDCOM RSG2200 Specifications download pdf (Page 26)

Chapter 3

Communication Ports

RUGGEDCOM RSG2200

Installation Guide

20 Copper Ethernet Ports

Section 3.1

Copper Ethernet Ports

The RSG2200 supports several 10/100/1000Base-TX Ethernet ports that allow connection to standard Category

5 (CAT-5) unshielded twisted-pair (UTP) cables with either RJ45 male connectors. The RJ45 connectors are

directly connected to the chassis ground on the device and can accept CAT-5 shielded twisted-pair (STP) cables.

WARNING!

Electric shock hazard – risk of serious personal injury and/or equipment interference. If shielded

cables are used, make sure the shielded cables do not form a ground loop via the shield wire and the

RJ45 receptacles at either end. Ground loops can cause excessive noise and interference, but more

importantly, create a potential shock hazard that can result in serious injury.

Figure 17: 1 x 10/100/1000Tx with RJ45 Ports (1CG01)

Figure 18: 2 x 10/100/1000Tx with RJ45 Ports (CG01)

Figure 19: 2x 1000Tx SFP with RJ45 Ports (CG55)

Each port features an LED that indicates the state of the port.

State Description

Yellow (Solid) Link established

Yellow (Blinking) Link activity

Off No link detected

The following are the pin-out descriptions for the RJ45 connectors:

Figure 20: RJ45 Ethernet Port Pin Configuration

Name

10/100Base-TX 1000Base-TX

Description

1 RX+ BI_DB+ Receive Data+

or Bi-Directional

2 RX- BI_DB- Receive Data-

or Bi-Directional

3 TX+ BI_DA+ Transmit Data+

or Bi-Directional

4 Reserved (Do Not Connect)

5 Reserved (Do Not Connect)

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 45 46

No comments

Siemens RUGGEDCOM RSG2200 Specifications Page 26