Siemens RUGGEDCOM RSG2200 Installation Guide download pdf (Page 34)

Type Tests

6.1.2 IEEE 1613 Type Tests

IEEE Test

IEEE

1613

Clause

Description Test Levels

Enclosure Contact +/- 2kV , +/- 4kV , +/- 8kV

C37.90.3 9 ESD

Enclosure Air +/- 4kV , +/- 8kV , +/- 15kV

C37.90.2 8 Radiated RFI Enclosure ports 35 V/m

Signal ports +/- 4kV @ 2.5kHz

D.C. Power ports +/- 4kV

A.C. Power ports +/- 4kV

C37.90.1 7 Fast Transient

Earth ground ports +/- 4kV

Signal ports 2.5kV common mode @ 1MHz

D.C. Power ports 2.5kV common, 1kV differential mode @ 1MHz

C37.90.1 7 Oscillatory

A.C. Power ports 2.5kV common, 1kV differential mode @ 1MHz

Signal ports 5 kV (Failsafe Relay)

D.C. Power ports 5 kV

C37.90 6 H.V. Impulse

A.C. Power ports 5 kV

Signal ports 2kV AC

D.C. Power ports 1.5kV DC

C37.90 6 Dielectric Strength

A.C. Power ports 2kV AC

Table 8 - IEEE 1613 Type Tests

Notes:

 If the unit contains copper ports the IEEE 1613 conformance is Class 1 (During

disturbance errors may occur but recovery is automatic).

 If the unit contains all fiber ports the IEEE 1613 conformance is Class 2 (During

disturbance no errors will occur).

6.1.3 IEC Environmental Type Tests

Test Description Test Levels

IEC 60068-2-1 Cold Temperature Test Ad -40 deg. C, 16 Hours

IEC 60068-2-2 Dry Heat Test Bd +85 deg. C, 16 Hours

IEC 60068-2-30

Humidity (Damp

Heat, Cyclic)

Test Db 95% (non-condensing), 55°C, 6 cycles

IEC 60255-21-1 Vibration 2g @ (10-150) Hz

IEC 60255-21-2 Shock 30g @ 11 ms

Table 9 - Environmental Type Tests

Note:

1. Ruggedcom specified security levels

2. Meets Class 2 requirements for an all fiber configuration. Class 1 for copper ports.

RuggedCom

RuggedSwitch

RSG2200 Installation Guide rev115

1 2 ... 29 30 31 32 33 34 35

Comments to this Manuals

No comments

Siemens RUGGEDCOM RSG2200 Installation Guide Page 34

Comments to this Manuals

Related products and manuals for Networking Siemens RUGGEDCOM RSG2200