Siemens RUGGEDCOM RSG2200 Installation Guide download pdf (Page 23)

Installation

4.6 Console Port Wiring

A RS232 console port for configuration and management of the device is located on the LED

display module shown in Figure 22. This port is intended to be a temporary connection during

initial configuration or troubleshooting and allows for direct access to the serial-based management

console. The connection is made using the DB9-Female to RJ45 console cable included in the

device packaging shown in Figure 23. Console connection settings are: 57600 baud, no parity

bits, 8 data bits, and 1 stop bit.

Figure 22: Console port location on display board Figure 23: RSG2200 Console cable

For user reference, the console cable pin-out is show in Table 5.

RuggedCom RS232 over RJ45 pin-out specification

nal Name

(

PC is DTE

)

DB9-

Female

RJ45 Male

DCD

–

Carrier detect 1

RxD

–

Receive data

(

to DTE

)

TxD

–

Transmit data

(

from DTE

)

DTR

–

Data terminal read

nal GND 5

DSR

–

Data set read

RTS

–

Read

to send 7

CTS

–

Clear to send 8

–

Rin

Indicator 9

Table 4: RS232 over RJ45 console cable pin-out

After initial configuration, the device can be configured via a number of new mechanisms such as

Telnet, SSH and the built-in web server. Consult the ROS

User Guide for further details.

NOTE: This port is not intended to be a permanent connection and the cable shall be less than 2m

(6.5 ft) in length.

RuggedCom

RuggedSwitch

RSG2200 Installation Guide rev115

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 34 35

Comments to this Manuals

No comments

Siemens RUGGEDCOM RSG2200 Installation Guide Page 23

Comments to this Manuals

Related products and manuals for Networking Siemens RUGGEDCOM RSG2200