Siemens CP 1515 Operations Instructions download pdf (Page 69)

Configuration Using the Wizards of Web Based Management

Operating Instructions SCALANCE W78x

dress Settings (Client Mode only)

Assigning

ernet port of

the SCALANCE W78x client before it can be reached. This MAC address is used

client for wireless communication with the access point.

nt,

– Automatically, the client adopts the source MAC address of the first frame

that it receives over the Ethernet interface.

– Manual entry by the user.

AC addresses need to be served downstream from the client,

the following setting is available for SCALANCE W746-1PRO and SCALANCE

W747-1RR:

– Layer 2 Tunneling

This setting meets the requirements of industrial applications in which MAC

address-based communication with several devices downstream from the client

is required. Clients with this setting cannot connect to standard Wi-Fi devices

and SCALANCE W access points with firmware V3.0 or older.

Note

The layer 2 tunneling setting is available only with the following model variants:

• SCALANCE W78x in client mode

• SCALANCE W746-1PRO

• SCALANCE W747-1RR

C79000-G8976-C184-07

5.4.6 Adopt MAC Ad

the MAC Address

A MAC address must be specified for the device connected to the Eth

by the

● If there is precisely one MAC address to be served downstream from the clie

there are two ways of doing this:

These settings have no effect on communication with standard Wi-Fi device

● If up to eight M

The SCALANCE W746-1PRO and SCALANCE W747-1RR devices can also

provide access to a wireless network for several Ethernet devices (IP mapping).

For an access point with MAC filtering, only one MAC address is visible to the

SCALANCE W78x client, there can be no filtering according to the MAC addresses

of the Ethernet devices.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 273 274

No comments

Siemens CP 1515 Operations Instructions Page 69