Siemens FUS1010 User Manual download pdf (Page 11)

Manual Addendum 1010FMA-14

May 2002

1010N-2 I/O Module

The conventional 1010N-2 I/O module provides the following:

z Two self-powered, isolated 4-20 mA current loops (signals Io1 and Io2) that are assignable and

spannable by the user to many flowmeter variables such as flow, sonic velocity, signal strength,

etc. These self-powered outputs also provide an industry-standard fault indication by dropping

to 2 mA if assigned to flow rate and under fault conditions. Note that these outputs, though

isolated from the system, are NOT isolated from each other.

z Two 0-10 Vdc outputs (signals Vo1 and Vo2) that are also assignable and spannable by the

user as above. These are also self-powered, but are not isolated from the system.

z Two 0-5000 Hz Pgen signals (Pgen1 and Pgen2) also assignable and spannable by the user.

These are TTL level pulses.

The 1010N/DN class of meters has a total of six analog outputs as indicated above. In addition (refer to

Installation Drawings 1010N-2-7 and 1010N-7-7):

z Alarms/Status/Totalizer pulses are generally presented as relay closures as either Mercury

Wetted Form 1A or Dry Reed Form C relays.

z Analog inputs, when provided, are in the form of 4-20 mA non-isolated inputs.

z The meter also has four non-isolated totalizer command lines providing Totalizer Clear and

Totalizer Hold (NoTot) functionality.

1010N-7 Expanded I/O Module Option

The Expanded I/O Module Option provides all of the above plus the following outputs:

z The four signals that drive the pulse generator outputs (Pgen 1 and Pgen2) and voltage outputs

(Vo1 and Vo2) of the meter create four current outputs: Aux Io1, Aux Io2, Aux Io3 and Aux Io4

(see diagram on next page).

z By spanning and assigning a system variable to 0-10 volt (Vo1 and Vo2) or 0-5000 Hz pulse

output (Pgen1 and Pgen2) the module simultaneously outputs these signals to the Expanded

I/O Module Option Aux outputs. For a 2-Channel meter the programming assignments are as

follows:

CHANNEL SIGNAL AUX Io METER MENU DISPLAY

CH1 Pgen1 Io1 Vo1

Vo1 Io3 Pgen1

CH2 Pgen2 Io2 Vo1

Vo2 Io4 Pgen1

TYPICAL 2-CHANNEL METER EXPANDED I/O OPTION CONNECTIONS

z Note that the four Aux Io outputs are externally powered.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 231 232

No comments

Siemens FUS1010 User Manual Page 11