Siemens 5930 Specifications download pdf (Page 36)

Chapter 2: Easy Setup Efficient Networks

5930 Business Gateway

User Reference Guide

Page2-8 Efficient Networks

Point-to-Point over Ethernet over RFC 1483

Selection of Point-to-Point Protocol over Ethernet over RFC 1483 will display the

following PPPoE Configuration page.

To continue the Easy Setup procedure with PPPoE, continue with the following steps:

Step1 Enter the PPP User Name and Password in the fields provided.

A PPP Username and password are required for authentication when the connection

is being established.

Step2 Enter the PPPoE Service Name in the field provided.

PPPoE requires the domain name of your network service provider. Use * as a default

(for all services). Enter the domain name of your network service provider in the

Service Name field.

Step3 Enter the timeout interval (measured in seconds) into the PPPoE Timer field.

PPPoE Timer will set a timeout interval for periods of inactivity. After the number of

seconds elapses, the PPP connection closes to limit timed connection charges from

your service provider. The default entry of “permanent” will keep the PPP connection

open constantly, with no timeout interval.

Step4 As required, click to select PPPoE only Filter.

This selection will filter all traffic on the bridge to allow PPPoE only. Check this box if

you will only connect to your network service using PPPoE.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 55 56

No comments

Siemens 5930 Specifications Page 36