Siemens SX Series Specifications download pdf (Page 28)

en Fault, what to do?

Fault table

Fault Cause Remedial action

“Check water supply”

display @ lights up.

Supply hose kinked. Install supply hose without kinks.

Tap turned off. Turn on the tap.

Tap jammed or calcified. Turn on the tap.

Flow rate must be min. 10 l/min.

when water supply is open.

Filter in the water supply blocked. Switch off the appliance and pull out

the mains plug. Turn off the tap. Unscrew

water connection.

Clean filter in the supply hose. Screw water

connection on again. Check for leaks.

Reconnect power supply. Switch on

the appliance.

Error code “:ƒƒ is lit. Filters 1j are soiled or

blocked.

Clean filters.

(See Cleaning and maintenance)

Error code “:ƒ… is lit. Waste water hose

is blocked or kinked.

Install hose without kinks, remove any

residue.

Siphon connection still sealed. Check connection to siphon and open if

required.

Cover on the waste water pump

loose.

Lock cover correctly.

(See Waste water pump)

Error code “:ƒ† is lit. Waste water pump blocked

or cover on the waste water

pump is not locked in position.

Clean pump and lock cover correctly. (See

Waste water pump)

Error code “:ƒˆ is lit. Mains voltage too low. Not an appliance fault, have the mains

voltage and electrical installation checked.

Downloaded from DishWasher-Manual.com Manuals

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 41 42

No comments

Siemens SX Series Specifications Page 28