Siemens Industrial Ethernet Switches SCALANCE X-200 User Manual download pdf (Page 222)

Configuration / diagnostics using remote mechanisms

6.3 Configuration using Web Based Management (WBM) and Command Line Interface (CLI)

SCALANCE X-200

222 Operating Instructions, 12/2011, A5E00349864-19

Syntax of the Command Line Interface

Table 6- 29 Switch LLDP - CLI\SWITCH\LLDP>

Command Description Comment

info Displays the current LLDP

settings.

lldpport [ports] <mode> Changes the LLDP settings for

one or more ports.

The <mode> parameter can

have the following values:

 RX - receive only

 TX - send only

 TX RX - send and receive

 D - disables sending and

receiving.

Example:

The command "lldpport 1,2,3 rx"

specifies that LLDP frames are

only received on ports 1-3.

Administrator only.

Note

With X-200IRT IE switches, only the following settings are possible:

 Port sends and receives LLDP frames.

 LLDP frames are sent but not received.

6.3.5.33 The "Switch DCP" WBM menu

Configuring Discovery and basic Configuration Protocol frames

This dialog allows you to configure the handling of frames of the Discovery and basic

Configuration Protocol (DCP) per port.

The DCP protocol is used to detect nodes in a network and to assign basic parameters such

as the IP address, system name etc. to them.

To allow the logical structuring of networks, the sending of DCP frames can be enabled or

disabled port-oriented on an IE Switch X-200.

Note

The sending of DCP frames can be disabled in STEP 7 using the "End of detection of

accessible nodes" function.

1 2 ... 217 218 219 220 221 222 223 224 225 226 227 ... 295 296

No comments

Siemens Industrial Ethernet Switches SCALANCE X-200 User Manual Page 222