Siemens Industrial Ethernet Switches SCALANCE X-200 User Manual download pdf (Page 117)

Product properties

3.26 C-PLUG (configuration plug)

SCALANCE X-200

Operating Instructions, 12/2011, A5E00349864-19

117

Note

Combinations other than those shown in the table are not compatible with each other.

Note

If a C-PLUG is adopted in a compatible device as shown in the table, the system name of

the original device is adopted both in the system name and in the PNIO device name of the

compatible device.

Using a previously written C-PLUG

If you want to insert a C-PLUG that has already been used and has been written to an IE

Switch X-200 with a different configuration, the existing C-PLUG data must first be deleted.

Note

An IE Switch X-200 normally starts up with the configuration of the C-PLUG, assuming this

was written to by a compatible device type. If the C-PLUG was written by an incompatible

device type, the basic device will not start up fully and signals an error. The WBM menu

"System C-PLUG" is displayed automatically. Here, you can use the "Modify C-PLUG"

function to specify whether or not the device operates with a C-PLUG.

If you select operation with a C-PLUG, this can be initialized either with the factory defaults

or with settings from the internal memory of the device.

Diagnostics

Inserting a C-PLUG that does not contain the configuration of a compatible device type,

inadvertently removing the C-PLUG, or general malfunctions of the C-PLUG are indicated by

the diagnostic mechanisms of an IE Switch X-200 (LEDs, PROFINET, SNMP, WBM, etc.).

Inserting in the C-PLUG slot

The C-PLUG is not supplied with the IE Switches X-200. It is available as an optional

accessory.

The slot for the C-PLUG is located as follows:

● On the IE Switch X-200 on the back of the device

● On the IE Switch XF-200 on the left hand side of the device

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 295 296

No comments

Siemens Industrial Ethernet Switches SCALANCE X-200 User Manual Page 117