Siemens DE18401 User Manual download pdf (Page 11)

Cleaning

Simply wipe the appliance with a damp cloth.

Do not use intensive or abrasive cleaning agents.

Customer Service

We ask you to always provide the E-No. and the FD-No. of

your appliance when calling in a customer service engineer.

You will ﬁnd the numbers on the inner side of the fold up

operating panel on the continuous-ﬂow heater.

A fault, what to do?

If your appliance does not operate as required, it is often due to a very minor problem. Please check whether you can remedy

the fault yourself by using the following guidelines. You will save yourself the costs of an unnecessary visit by customer service

personnel.

Fault Cause Solution Who

Water ﬂow-rate is too low. The ﬁlter in either the water tap or

the showerhead is clogged

Remove the ﬁlter and either

clean it or descale it.

Customer

The ﬁlter in the corner regulating

valve is clogged.

Get a servicing expert to clean the

ﬁlter.

Servicing

expert

The ﬁlter upstream from the check

valve in the cold water supply inlet

is clogged.

Remove the ﬁlter and either

clean it or descale it.

Servicing

expert

The desired water temperature is

not reached.

The continuous-ﬂow heater is

connected to a thermostatically-

controlled water tap.

Set the temperature on the continu-

ous-ﬂow heater to “max”.

Customer

The power limit has been reached.

Water ﬂow-rate is too high and/or

the cold water supply temperature

is too low.

Reduce the ﬂow-rate at the water

tap supply.

Customer

By a qualiﬁed professional:

use the angle valve to regulate the

ﬂow-rate.

Check the ﬂow-rate limiter or re-

place it with a smaller one.

Servicing

expert

The water is not sufﬁciently warm. The fuse in the house electrical in-

stallation has tripped/blown.

Check the fuse in the house electri-

cal installation.

Customer

The appliance‘s automatic circuit

breaker has been tripped.

Get the appliance‘s automatic cir-

cuit breaker checked by an electri-

cian. Check the permissible supply

temperature.

Servicing

expert

The power limit has been reached.

Water ﬂow-rate is too high and/or

the cold water supply temperature

is too low.

By a qualiﬁed professional:

use the angle valve to regulate the

ﬂow-rate.

Check the ﬂow-rate limiter or re-

place it with a smaller one.

Servicing

expert

From time to time, cold water

ﬂows out.

The air sensor in the appliance de-

tects air in the water and momen-

tarily switches the heating element

off.

After a few seconds, the continu-

ous-ﬂow heater automatically goes

back into operation.

Continu-

ous-ﬂow

heater au-

tomatically

resolves

problem

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Comments to this Manuals

No comments

Siemens DE18401 User Manual Page 11

Comments to this Manuals

Related products and manuals for Water boiler Siemens DE18401